NASA's fake Moon pictures were taken at various locations such as KSC, JSC, LRC, and of course the odd one or two desert locations. I would also like to point out to that the art of faking both still photographs, and movie film is as old as photography and film itself. The 1930's film "King Kong" showed a huge gorilla scaling up the Empire State building. If it's on film are we led to believe it's real? No of course not, but that is exactly what PAN's, (Pro Apollo Nutters) are claiming. Their ridiculous debunking claim is that digital manipulation of photographs and film was not available back in the 1960's, but they did not have digital artifacts back in 1930 when the film "King Kong" was made.  Langley is NASA's space research facility, and staff are sworn to secrecy. All files pertaining to the Apollo (fake Moon missions) are stored there and not due for declassification until 2026. Other artifacts including the burnt out Apollo 7 capsule which killed Grissom, Chaffe and White. They have the facilities to perform anything, fake backgrounds, simulated orbiters etc. First piece of evidence is the large 250 foot traverse crane shown below. Notice fake Moon crater surface created beneath the crane.

  This crane was PURPOSELY built in 63/64 to perfect the lunar landing as close as possible to the real thing, and used to suspend both astronauts, and the LM itself. It enabled movement of the astronauts and LM in all directions, i.e., up down, left right, forward and reverse. The trial runs were so good, and with NASA, fully aware that a Moon landing was impossible, opted to use the setup for faking the alleged   film of lunar landing, and take off, whereby the flag is blown over. 

  According to Bobby Braun and other NASA officials the idea was to teach the astronauts how to land a rocket propelled LM. However NO ROCKET POWERED LM WAS EVER SUSPENDED FROM THIS CRANE. In any case anyone with the slightest gumption knows that it is IMPOSSIBLE to control a rocket engine. If the PAN's disagree, then perhaps they could direct me to a video or film showing how the feat was, or could be accomplished. The landings were controlled purely by traverse and lowering of the LM in the same way as a conventional crane.

  Below are more pictures showing mock LM suspended from this crane. In the center (left) picture note the circular objects on the ground floor. The vast expanse of ground area beneath this crane was ideal for creating mock lunar landscapes. In reality the area was covered with gray ash, (possibly from some coal fired power station or boiler house), or plain cement. The circular objects were then raised by crane to create authentic looking Moon craters, as shown later.

  The far right picture above is a time lapse sequence taken at night. Notice spotlights on crane gantry, and how it illuminates the ground surface. The mock LM was traversed full length of crane, and simultaneously lowered at the same time in order to create an authentic looking lunar landing, when viewed from within the mock LM itself. Power supply to the mock LM was by cable from crane tower. This enabled a large fan, (fitted beneath the mock LM), to create the dust scatter effect of a rocket engine as it descended to the fake Moon surface. The film shown to public of the LM supposedly blasting off from the Moon's surface was also created beneath this crane at LRC. The mock LM was simply attached to the crane, and hoisted very rapidly at the same time a pathetic looking blast off sparks was enacted beneath it. The film was then speeded up for showing to the public, and it is interesting to note that the camera filming this sequence cut short once the LM had reached the crane maximum height. In other words WHY didn't the camera continue to film the LM until it was out of view? Quite simply because it was not possible to do under the circumstances in which the "lift off" was faked.
 

  The above pictures were taken by Bob Nye on June 20 1969, one month before Armstrong, err, supposedly stepped on the Moon. Picture on right shows the lander hovering above fake Moon crater surface beneath the crane. Believe me folks this is how it was done, even if Pro Apollo Nutters say no way. Picture on left, taken at night, looks like a realistic Moon setting, although I am in no doubt that some out there will actually say this photo is the Moon. I have heard so much BS from the Pro Apollo Nutters nothing would surprise me. The light source seen in left picture is the same light source that highlights Buzz Aldrin in the controversial picture of him allegedly on the Moon. Those lights are fixed at top of crane gantry, as shown in earlier picture.

  There is a classic piece of film, and I have only ever seen it once. It shows two astronauts supposedly on the Moon, but one astronaut is following behind the other in a dead straight line, and at a fixed distance. Two partners in a strange desolate place would not walk in such a stupid fashion, and so far apart. It's obvious both are following a given line/route, i.e., the line or route in which the two overhead cranes are forcing them to follow. In the pictures below, it can be seen how astronauts were suspended from this crane. It is interesting to note that high backward leg swing in far left picture. That high backward leg swing is identical to the back leg swing in the Apollo 17 photo of Harrison Schmitt supposedly tripping up on the Moon (shown right). In another video sequence of Apollo 17 astronauts supposedly cavorting on the Moon, one of them is actually suspended 2 feet horizontally off the ground. This sequence lasts for a couple of seconds, so how do NASA officials explain that, and why is it that no one else has passed comment on this totally absurd picture shot? It's clear evidence that person in space suit is suspended from wires, or some other line. The picture below shows astronaut suspended via a tubular spring to create the "bounce effect" as though they were walking in reduced gravity on the Moon.
 

  Picture on left is a view taken from top of the Langley crane, looking down onto fake lunar surface created beneath. Picture right shows Donald Hewes beneath the Langley crane. Hewes created the fake lunar surface, and was heavily involved in the fake lunar landing and lift off video's.
 

  Size does matter believe me, especially when NASA want to create a fake lunar surface as shown in the above picture on left. It literally dwarfs the two men stood in front of it. It's unbelievable the time, trouble and expense that NASA incurred purely to fake the lunar missions. It was of course done purely to convince the world they were the leaders in space. This very large picture, and others were used in conjunction with a rail mounted camera, which also focused on a large rotating PLASTER PARIS model of the Moon, ) shown on the right).   NASA knew, (after Kennedy's speech in 61), that a lunar landing before 1970 was impossible. Realizing this they had no option but to fake the missions. A program was launched at LRC to design props/backgrounds etc. to convince the media they had achieved the goal set by Kennedy. The pictures above were scanned from a book, hence the poor quality, however the following pictures are from NASA.
 

  The high resolution picture above left shows a 20' diameter sphere which can be rotated from below. In the left of that picture can be seen a huge blank placard. This is the scene before LRC staff began work on converting the sphere to an authentic looking Moon complete with craters, ( for lunar approach), and the placards were to be lunar orbit. Notice also the rail track around placards, (there were 3 placards in all). Note moving trolley on that track. The camera was mounted on that trolley. It first began to film the rotating sphere, (lunar approach), it then swung around and began scanning the fake lunar surface on placard, (lunar orbit). 
 

  The picture above right shows the sphere after modeling work. Pretty impressive eh? Notice how background is in the dark. Remove that bloke from the picture and you could EASILY pass this photo as being taken by the Apollo command module circling the Moon. It is evident that there were many people involved in the faking of Apollo, and NASA claim that if it were faked someone would have spoken out by now. Well LRC staff are sworn to secrecy, and they must have been 100% in favor of the fakery, otherwise they would not have participated in the first place.
 

The two pictures above show how LRC made "plaster paris" copies of the Moon craters on the placards. They are checking that the craters are exactly to scale and layout, as craters shown on the lunar photographs previously taken by high magnification telescope. (Editors Note: Lunar Orbiter Photos 1965-1967) Notice the sphere in left hand picture after modeling work. This sphere had a light inside it which was translucent on the outside, hence the appearance. The large placards with Moon craters was also backlit. Turn off all your lighting, and you end up with the picture shown below left. This is how the Moon would look in the void of space if you could get close enough to it, however no one, not even Armstrong could get anywhere near to the real thing.
 

  NASA claim that picture on the right is far side of Moon, taken by Apollo 8. Compare this sphere with one shown above in left hand pic. It speaks for itself does it not? In all of these pictures notice the black background. This of course made it easier for touching  up photo's to ensure that background space was indeed black.
 

  This final picture shows Charlie Duke (pointing), and John Young, at the simulator controls for lunar approach/orbit. The picture on TV screen is reminiscent of the pictures we saw on our TV screens. We were told it was the Moon, but the picture showing on TV screen in photograph is not the Moon. It is a camera filming the plaster paris model of Moon.